Chelsio Communications Chelsio T5 User's Guide download pdf (Page 390)

100

101

Chapter XXI. Unified Boot

Chelsio T5/T4 Unified Wire For Linux Page 390

2. Flashing firmware and option ROM

Use any one of the below mentioned methods to flash Option ROM onto Chelsio CNAs:

2.1. Using Flash Utility

Chelsio legacy flash utility (cfut4.exe) is used to program the PXE Option ROM image onto

the Chelsio CNAs.

Example: This example assumes that you are using a USB flash drive as a storage media for

the necessary files. Follow the steps below:

i. Create a DOS bootable USB flash drive.

ii. Create CHELSIO folder on the USB flash drive.

iii. If you haven’t done already, download ChelsioUwire-x.xx.x.x.tar.gz from Chelsio Download

Center, service.chelsio.com

iv. Untar the downloaded package.

v. Copy all the files from ChelsioUwire-x.xx.x.x/Uboot/OptionROM and place them in the

CHELSIO folder created on the USB flash drive.

vi. Plug in the USB flash drive in the system on which the Chelsio CNA is installed.

vii. Reboot the system and enter the BIOS setup.

viii. Make the USB flash drive as the primary boot device. Save the changes and exit.

ix. Once the system boots from the USB flash drive, change your working directory to

CHELSIO directory:

C:\>cd CHELSIO

Only Legacy environment currently supported on T5 and T4 adapters.

Note

1 2 ... 385 386 387 388 389 390 391 392 393 394 395 ... 459 460

Comments to this Manuals

No comments

Chelsio Communications Chelsio T5 User's Guide Page 390

Comments to this Manuals

Related products and manuals for Software Chelsio Communications Chelsio T5